If you have any feedback on how we can make our new website better please do contact us and we would like to hear from you. 
Products

 

Models 3P12 and 6P12

Model 3P12 6P12
_3P12B 6P12B
Fuel (Nat Gas special order) propane propane
BTU Input (max.) 3000 BTU 5,200 BTU
Power 12 Vdc 12 Vdc
Fuel Consumption 1/8 lb /hr (34 hr per gallon) 1/4 lb /hr (17 hr per gallon)
Operating Cost .04 /hr .08/hr
Current Draw...start 5 amp (for 2 minutes) 5 amp (for 2 minutes)
.........................run, exhaust blower less than 0.5 amps less than 0.5 amps
Gas Pressure 11" W.C. 11" W.C.
Size ..................height 14" 21"
.........................width 12" 12"
.........................depth 5 3/8" 5 3/8"
Gas Connector 3/8" flare 3/8" flare
Mounting surface or 2 3/4" recessed surface or 2 3/4" recessed
Exhaust Vent Tube Size 1 1/2" O.D. 1 1/2" O.D.
Area Heated Up to 100 sq. feet * Up to 175 sq. feet*
Finish** powdercoat powdercoat
Ignition (no flash, no flame) Automatic Automatic
Automatic Temperature Control Includes wall thermostat Includes wall thermostat

Specifications subject to change.

* Depends on climate, insulation, room heat loss.

** Color on demand.   Heater case color  may be almond (off white), silver, bronze, black, forest greeen, appliance white, taupe and more.      .

Safety System:........................Power exhaust venting removes 100% of combustion by-products. Automatic Safety Shut-off in case of malfunction. No open windows are required. Operates safely at altitudes above 5000 ft. 

Vent Kit...................................Vent kits have all necessary installation hardware included for most common installations. Includes 3 foot length (1 1/2" I.D.) flexible exhaust hose, exhaust vent terminal, remote wall thermostat, mounting screws, and easy-to-follow installation instructions. Chose between an exhaust thru-fitting , a sidewall exhaust terminal, or a stainless steel scoop exhaust terminal.

Heaters built according to rigid design standards for Vented Catalytic heaters to insure safety and reliability.

 



Please note that  due to demand, lead time for new heaters
is likely 8 + weeks.




A & L Enterprises

platcat@att.net

Phone: (360) 446-5355

 

 

 

 

 

 

 
 
  Site Map